SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
05 Piaggio X9 Evolution 250 discussion forum:RE: mark clerkin |
| RE: mark clerkin |
| grumster said 2005-11-16 18:08 |
| I have a scan of the workshop manual. Translating from the Italian it goes as follows, but please note I have no practical experience of these tasks and an imperfect grasp of the language. To remove the drive belt, first open the cover. Next, block the motor drive shaft pulley using an appropriate tool, unscrew the nut and remove the washer and half-pulley. The belt can then be lifted off. The minimum belt width should be 21mm. Less than that and it´s time to replace it. The manual recommends replacement every 18000km. Refitting is basically the same in reverse. The whole thing doesn´t look difficult; it´s basically a modern version of the Daf Variomatic transmission used in cars in the 1960´s and 70´s. Mechanically simple but highly effective. |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 2005 Piaggio X9 Evolution 250 informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 05 Piaggio X9 Evolution 250. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |