scarred up slider on variable venturi cause leanout?

82 Kawasaki KZ 750 CSR (KZ 750 M1) discussion forum:


scarred up slider on variable venturi cause leanout?

scarred up slider on variable venturi cause leanout? 
Dan said 2009-06-28 01:07 
 
Soaked carburetors and all internal parts in ultra-sonic sound cleaner, hot soapy solution. spots of teflon coating came off floating variable venturi pistons. Can this cause a lean out condition at lower to mid speed ranges? Only way bike will run is with enrichener on full choke. I have been completely through these carbs twice, with air and carb cleaner in a spray can. Near as I can tell, all passages and jets are clear. Sliders seem to float freely with finger. Any suggestions? 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1982 Kawasaki KZ 750 CSR (KZ 750 M1) information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 82 Kawasaki KZ 750 CSR (KZ 750 M1). You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.