SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
02 Harley-Davidson FXSTDI Softail Deuce discussion forum:RE: Tach wiring connection |
| RE: Tach wiring connection |
| ThomWV said 2008-07-15 16:23 |
| First off the Deuce did not come with a tach, it is an accessory item. The connections for it are, therefore, somewhat arbitrary in that the installer might chose to find a power supply or ground point other than the one recommended by Harley. That said here are the connections. First there is power supply and the connection for that should be a aplice into the main harness made where the main harness passes near the rear tank mounting point. The ground wire from the tach is often attached at the rear tank mounting point as well, it will be a black wire attached to a bolt. The next connection is the tach sensing wire. Harley did not put a tach on the Deuce but they did put the wire in the harness in case you wanted to install one later. Remove the dash panel, which is held on by one screw in the front and two bolts on the back, and you will find a blue wire just forward of where your keyswitch mounts. That is the tach sensor wire and I think you will find that your connection is bad. |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 2002 Harley-Davidson FXSTDI Softail Deuce informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 02 Harley-Davidson FXSTDI Softail Deuce. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |