Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
Mr. Thomas Crous
T.C.Crous said 2010-09-10 18:15
I need to set up my RG 125F power valve and require the correct settings. The power valve servo-motor was open when I purchased the bike and the bike is sluggish on acceleration.
what is the voltage output from the servo on switch ON and what should the Voltage output be when fully open.? Must the servo drive rotate when the ignition is switched on?