Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: engine miss
adrian said 2010-04-26 18:18
Make sure you´re coil is grounded properly, your plug gaps are proper.. or new plugs and also check the resistance on your coils. They should be really high.. the boots should be 10 ohms and the coils themselves like 90 or 100 ohms. Also.. the connection where your boot goes into the plug wire could be messed up. so snip a bit off and thread the boot back into it. Check for ANY wiring connection in the circuit that could be even a little loose.