Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
Mr John Henshaw
john the pom said 2009-08-09 15:26
Need too know; camshaft seal on my 03 thunderbird blew right on where the half round cut out is , so i got a new seal and put it on. But this one is also being put under pressure and blowing the seal out . Is the seal supposed too be glued in position in the cut outs? is the crank case supposed to be pressurised, should there be a relief valve somewhere to vent crankcase? john