Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
de baffeling pipes on c90t
marlin said 2009-05-01 09:40
I recently learned a very inexpensive way to get a harley sound out of a c90. i cut the header pipes just before they turned into the catylic converter, removed it, bent a couple of pieces of 1 3/4 inch pipes and bought a set of mufflers for 25.00 at a salvege off a c50 boulevard. i cut the ends off the pipes with a chop saw just above the weld. the whole baffel will slide out. they have 3 diffusers it them. i cut the baffel where there would only be 1 diffuser and made the hole in it bigger. then put the about 6 inches of the baffel back in the muffler, drilled a hole it the bottom through the muffler and baffel to secure it. it sounds hard but it took me about 3 hours to do it. i had to make some brackets and stop up 1 tube on 1 muffler and use clamps and modify the heat shields, but a great sounding and good looking exhaust for 25 bucks is a lot better than 5 or 6 hundred. marlin