Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
SURGING AND BOGGING DOWN
macintyreservice said 2009-03-11 18:28
I Have 1977 dt400, carburator needle valve clip position is in the middle slot, and it surges at slow speeds, if i move it up one notch, then it will not surge as much and then begins to break up at igh rpm,s and if I move it down one notch, the throttle runs away from you at an idle, got complete other carb, and switched it and it does the same thing.If I go to far down on the setting it gets worst, and to high on the setting it gets worst the other way, please help.