Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
Senior Engineer
David Keith said 2008-09-01 14:30
Just putting my 1975 KZ900 back together when I found a spacer left over. It is a slip fit onto the shifter shaft (0.48 I.D.), 0.70 O.D. x 0.57 long. It has some rust on the outside diameter so I think it fits outside the engine. But I cannot remember where it came from... Any suggestions?