Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: oil injection pump [autolube] 77 DT 400
jb said 2008-06-05 15:45
There is no checking flow, the only way is to follow Clymers manual exactly then a tweek further for insurance-better to run a little more oil flow. Or you can&should do is to remove & plate/block off the pump (and use pre-mix 32:1 ratio) which is what you need to do if you have a good engine or fresh rebuilt engine. Good Luck