Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
Mike Smith
cocopop said 2007-08-21 15:03
I did a very silly thing -had the cover off inspecting the condition of the front sprocket. Having cleaned off the chain-flung gungeand detemined that thesprocket was serviceable, I reassembled but put the spacer that should be for the front bolt of the hydraulic unit on to the push rod for the clutch release. When I tightened up the bolts, the spacer popped out the rubber seal for the push rod allowing the engine oil to escape -ugh, I was weary at the time. ? IS THIS A COMPLETE ENGINE SPLIT AND STRIP ? or can it be repaired more easily. My lovely ยด03 V-Strom DL1000 is caput at the minute. Mike, Dublin ,Ireland