Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: carb setup
Kevinm said 2007-08-05 19:08
Your slow speed jets are probably still clogged. They are pressed in and you can pry them out with a smal pair oof vise grips. Use a welding tip cleaner rod and carb cleaner to clean out the jet. The hole s are very small and be careful not to enlarge them when you clean them. You can also heat them with a torch until they are red, and it will burn the crud out.