Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: problems with gaskets
V4 said 2006-10-22 22:54
I have found the CM250C to be cold blooded, that is it often doesn´t like to start after sitting for even a few days. The solution I found was to open the needle valve (flat bladed screwdriver)on the float chamber and drain some fresh fuel from the tank down into the chamber while catching the expelled fuel from the rubber drain hose into a glass jar for the lawnmower. Bike then starts right up.