Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: Jet Kit?
DRay said 2006-08-31 04:18
I don´t know if I mentioned that I had to raise my needles about 1/8 inch to get it to run right. The K&N filter instructions recommended this. I rebuilt my carbs just by buying new float needle valves and gaskets. I couldn´t get pilot jets. The dealership said that they were unavailable so I just cleaned the old ones out pretty well.As I said earlier,The #120 didn´t allow enough gas flow. Raising the needles took care of the low end problem (1000rpm-4000rpm) and drilling out the jets took care of the high end problem (4000+ rpm).I developed the hesitation at first twist of the throttle when I drilled out the main jets. I think it is getting just a little to much gas as low end. I think the #130 jets will solve the problem but I haven´t got them yet. Harley Davidson solved the slow response problem by adding an accelerator pump. Oh yeah. I raised the needdles by carefully taking a rotary tool and cuting a new small groove for the \