Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: 86 Honda VFR 750 carb question
masonv45 said 2005-08-19 19:13
Silicone and gas donĀ“t mix. Gas eats silicone very quickly. It also gums up just about everything it touches. You will have to pull the carbs and clean them again. The tiny passages in the carb and the holes in the slow and main jet could be clogged.
I subscribe to a message board: www.v4hondabbs.com and have been for years. Check out the vendors section. They sell carb kits and just the o-rings if you ask nicely. Tell BillyC that Masonv45 sent you. I would recommend you get at least the float bowl gaskets and the fuel tube o-rings.