Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: Tacho / ecu fault
Aceinthehole said 2004-12-14 12:23
Kind of a dumb question, but after you replaced the servo, did you adjust the exup valve properly? Line up the holes, tighten the cables with the appropriate slack? If the exup is going full close prematurly and resisting the servo, I think you will get a fault code. I would just double check that the exup is adjusted properly. If you havenĀ“t already.