Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: carberator diagrams ?
Dan said 2004-06-16 02:01
You need to turn the idle jets in and count the amount of turns till it is all the way in. Then remove the idle richness screws with the tabs on them. There will be a small rubber ring and a smal metal washer, the rubber ring goes in first and then put in the metal washer( make a note to be careful of these). Need to work carb spray back and forth between where the idle richness screw goes and the non-removable pilot jet, next to the main jet. Once passage is cleared, turn the idle richness screws in all the way then back them up the amount of turns you counted before. Any more questions, e-mail me at irishdaddy1977@aol.com