Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: 84 CM250 need drive belt
Stebekk said 2012-09-14 00:02
I couldn´t find a belt anywhere but did see a forum post somewhere that said you can swap out the sprockets for the ´82 chain sprockets and just use a chain. I just completed that swap and it was relatively straight forward. Only thing I had to do was add a lock washer on the rear sprocket posts between the post and the sprocket. Otherwise there is too much play between the retaining clip and the sprocket. I´m in Canada as well.