Report this message as spam or having improper contents

Moto Guzzi Le Mans 850 discussion forum:


Report this message as spam or having improper contents

Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this page by programmed robots, we have to ask for the characters in the picture below.

 

This is a captcha-picture. It is used to prevent mass-access by robots. (see: www.captcha.net)

You must read and type the 5 characters within 0..9 and A..F:


I cannot read this picture.

 

Head questions 
Jerry P. said 2012-04-06 01:15 
 
I´m doing a top end eval. It´s my first time and I have the help of a good mechanic and some outside consultations second hand. I checked the end clearance on the rings. The spec is .030-.045 mm. Mine measure .0668 thereabouts. So I´m planning to replace the rings. My concern is the piston and cylinder bore. The bore is less then spec. It has little wear. The piston is similarly looking good, but below spec diameter. If I get new rings, what are the chances that they will be too big. Then I´ll have to bore out the cylinders and get new pistons. I´m already past my original budget by a bunch.I´d appreciate any experienced insight - Thanks - Jerry 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title
 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.