Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: Carb adjustment sequence
Mark W said 2011-12-31 22:10
G´day Alan , You should´nt touch these air screws / pilot screws they are factory set & do not have any real influence over rich-lean adjustment . All adjustments should start with the slide needle height , factory set @ the centre of 5 positions . Shift down for leaner . These simple adjusts will usually cover a change of exhaust system . Change of cams , compression , CDI will require a few more tries . Your best bet is to get the bike on a dyno with full exhaust analysis . But keep an eye on those plugs & don´t burn any valves . Mark .