Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
mr
scott said 2011-03-23 12:31
looking for some advise on my xl600lmf its a very clean bike and hasnt been messed about with at all, the bike starts and runs fine every time, but when im going over a certain rev, there is a massive flat spot. i originally thought this was a carb isssue, but i took them apart cleaned them and raised the needle one notch (onto the very bottom notch) to see if more fuel to the high rev carb would make a difference but it didnt, well it might have pulled a little better but problem still there so i put it back, am i looking at a electrical thing here? any advise would be appreciated. i dont see how giving it more fuel would fix it when it must of been running as it is fine at some point. so it pulls fine up to a point then just flat, if i open it right up it dies, if i accelerate very slowly it pulls, and if you make it through tthe flat spot it starts pulling again just in time for the red line ha ha. cheers, scott