SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
74 Harley-Davidson XLCH 1000 Sportster discussion forum:RE: i have question´s about my 74 XLCH 1000cc ironhead |
| RE: i have question´s about my 74 XLCH 1000cc ironhead |
| Sully said 2004-08-24 06:04 |
| you might just need to wear it in a little bit due to the fact that you have new plates and spacers that will "take a set" after a little burn-in. worst case try taking one set of plates out or make sure they didnt put too many in. be aware though that you will want to make or buy a spring compressor cause otherwise it is a hell of a job getting the pressure plate back on one of the studs far enough to start one of the self locking nuts ( I do it by hand but not for fun). Try a different oil ( you will want to change it anyway since it is shared with the transmission and you dont want the clutch break-in crud fouling it up. |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 1974 Harley-Davidson XLCH 1000 Sportster informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 74 Harley-Davidson XLCH 1000 Sportster. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |