SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
95 Yamaha FZR 1000 discussion forum:sprocket query |
| sprocket query |
| daron said 2004-09-22 02:43 |
| I have a 1994 FZR 1000 Exup which I have owned from new. The bike has around 40000 miles on it and developed a flat spot between 3500 and 4500 revs about 1500 miles ago. I had the bike dynojetted around 5000 miles ago as the emulsion tubes were worn and needed replacing. The power loss is more noticeable when the engine is hot so I checked the valve clearances and had to replace all the exhaust shims and 2 inlets because they were running tight. The flat spot is still apparent but less severe although still troublesome especially 2 up. Would an increase in rear sprocket size by 1 or 2 teeth assist in reducing this problem further and what would be the implications on fuel consumption and overall perfomance of the machine? Mechanically I have serviced the bike as per manufacturers guidelines and it has regularly been ridden hard solo and 2 up with touring luggage on. Thanks for your assistance with this matter. Regards, Daron |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 1995 Yamaha FZR 1000 informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 95 Yamaha FZR 1000. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |