SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
72 Suzuki GT 750 J discussion forum:RE: 1972 gt750 cylinder head machining |
| RE: 1972 gt750 cylinder head machining |
| jj said 2009-07-31 22:56 |
| Milling off 1mm is not a problem. Compression pressure and compression ratio are not the same thing. Compression ratio is the complete volume of the cylinder, head combustion chamber, gasket thickness ( area) etc. at bottom dead center divided by the volume it is compressed into at top dead center. This is called full swept volume and is how a 4 cycle engine is computed. The GT750 is a 2 cycle therefore actual compression doesn´t start until the exhaust port is closed thus lowering the \ |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 1972 Suzuki GT 750 J informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 72 Suzuki GT 750 J. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |