RE: mark clerkin

Piaggio X9 Evolution 250 discussion forum:


RE: mark clerkin

RE: mark clerkin 
grumster said 2005-11-16 18:08 
 
I have a scan of the workshop manual.  Translating from the Italian it goes as follows, but please note I have no practical experience of these tasks and an imperfect grasp of the language.

To remove the drive belt, first open the cover.  Next, block the motor drive shaft pulley using an appropriate tool, unscrew the nut and remove the washer and half-pulley.  The belt can then be lifted off.

The minimum belt width should be 21mm.  Less than that and it´s time to replace it.  The manual recommends replacement every 18000km.

Refitting is basically the same in reverse.

The whole thing doesn´t look difficult; it´s basically a modern version of the Daf Variomatic transmission used in cars in the 1960´s and 70´s.  Mechanically simple but highly effective. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.