RE: question

Husqvarna TE 410 discussion forum:


RE: question

RE: question 
verm1oil said 2009-11-28 06:37 
 
It´s easier to kick over my TE 410 with the exhaust valve lifter(decompression lever) pulled in (on the left h/bar)
ie pull in the lever, using the kickstarter - push the engine thru a couple of full cycles- to clear it out. Let go the lever. Again, slowly push the engine using the Kickstarter until it´s at top dead centre on the compression stroke. You´ll know this TDC because it´s the position the engine is in, just after it has sucked in fuel&air.
So after the sucking sound stops and just a bit more on the kickstarter until it kinda finds a point of resistance.
Now give it a good solid kick, with no throttle, it should fire.
If not, repeat the slow push thru on the kickstarter to get to TDC again, then give it a solid kick.
Mine can be a %&#!¤ to start if I drop it when hot.But responds well by clearing it out using the decomp. lever 1st.

Have fun
desertdirt 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.