00 Triumph Thunderbird discussion forum:

Mr John Henshaw

Mr John Henshaw

john the pom said 2009-08-09 15:26

Need too know; camshaft seal on my 03 thunderbird blew right on where the half round cut out is , so i got a new seal and put it on. But this one is also being put under pressure and blowing the seal out . Is the seal supposed too be glued in position in the cut outs? is the crank case supposed to be pressurised, should there be a relief valve somewhere to vent crankcase?
john

<<Previous Answer Discussion overview Report spam Next>>

Enter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

More 2000 Triumph Thunderbird information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 00 Triumph Thunderbird. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.

Title
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text
Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.

About Bikez.com.	Contact Bikez.com	Motorcycle catalogue
Our privacy policy	Do not sell my data	Motorcycle classifieds