RE: Tacho / ecu fault

Yamaha YZF 1000 Thunderace discussion forum:


RE: Tacho / ecu fault

RE: Tacho / ecu fault 
Aceinthehole said 2004-12-14 12:23 
 
Kind of a dumb question, but after you replaced the servo, did you adjust the exup valve properly? Line up the holes, tighten the cables with the appropriate slack? If the exup is going full close prematurly and resisting the servo, I think you will get a fault code. I would just double check that the exup is adjusted properly. If you haven´t already. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.