RE: Kickstand kill switch?

Yamaha XJ 750 discussion forum:


RE: Kickstand kill switch?

RE: Kickstand kill switch? 
Dennis said 2005-04-27 06:48 
 
Without benefit of a wiring diagram, allow me to offer some ideas. I´ve never had to tear into mine. So, depending upon whether the switch is "NO" (normally open) or "NC" (normally closed) with the kickstand is up, you can do either of the following. If "NO", then simply disconnect the switch and the warning lamp should disappear. However, beckermow indicates he bypassed it. That would suggest it is "NC" (kickstand up). In this case, you would need to disconnect the switch and jumper the connections (assuming it is a two-wire connector). Sometimes, you can get lucky with electrical spray (Radio Shack) and free up a sticking switch that has been out in the weather. Try that. In any case, if you don´t get the warning lamp turned off, you´re not going anywhere. Let us know if this helps. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.