Adding a light bar to a 2010 V-Star 650 Silverado.

Yamaha V Star Classic discussion forum:


Adding a light bar to a 2010 V-Star 650 Silverado.

Adding a light bar to a 2010 V-Star 650 Silverado. 
Reboot123 said 2011-10-21 18:49 
 
I purchased a new Kuryakyn Driving Light Bar KY-4001 with led turn signals. I also purchased the
1. KY-4005 Front Mounting Brackets - Vsta
2. KY-2328 Universal Wiring & Relay Kit
3. BBP-13-207 Cast Accessory Switch - 1 inch bar

I bought 2 wiring harnesses #2, & #3. I would like to use #3 if I could. It is the one that clamps to the handle bar. Both harnesses suggest you run power wires right from the battery posts.

1. Is there an accessory connection in the headlight I could use?
2. Is the hole in the headlight bezel big enough to get the wires through?
3. Are the battery posts on the top or side of the battery in a 2010 v-star 650 silverado. There doesn´t seem to be much room in there.
4. Also is it hard to get the battery out, and back in.
5. How does the rubber strap holding the battery in place disconnect?
6. What are those connectors in front of the battery for?

Going to try and install them myself, so I need all the direction I can get.

Tks
Reboot123 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.