RE: DT250 point ignition on DT400 ?

Yamaha DT 400 discussion forum:


RE: DT250 point ignition on DT400 ?

RE: DT250 point ignition on DT400 ? 
YAMAN said 2009-10-28 23:07 
 
yes i know i have to time it and will have that done. i will have the source and pulser ohm tested to see which one is bad but 99% of the time im told its the pulser that goes bad. and since its a sealed unit its unrepairable. i wish somebody knew how to repair a pulser coil that would be great.when i get them tested i will let you know. dont you think its weird that the bike would idle fine but when throttled it would run poorly like it was running on half a cylinder. when i first took the side cover off alot of rusty water ran out, i think that shorted out the stator. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.