RE: 1974 Yamaha dt360 help needed

Yamaha DT 360 discussion forum:


RE: 1974 Yamaha dt360 help needed

RE: 1974 Yamaha dt360 help needed 
Bozzinator said 2007-04-17 21:16 
 
The DT360 has 2 different compression realse valves. one on the second spark plug hole that can easily be taken off and replaced with a second spark plug and the other is on the front of the cylinder just like a Husqvarna chain saw. their is a small round frill that fits around the compression realse valve. in which the cable goes through. there is a little L shaped piece with a spring attached to it the peice is attached to the cable and it pivots. the short part of the L has a hole in it. the little shaft that moves forward to backward on the valve fits into the hole.there is a small hole in the shaft where a small pin goes through to hold the shaft outward thus making it hold compression and were the cable goes into the back of the motor I believe that mine is broken because it never moves!!!! the bike holds compression and that is all that matters. So i wouldnt worry about it. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.