DT250 rear turn signal fix

Yamaha DT 250 discussion forum:


DT250 rear turn signal fix

DT250 rear turn signal fix 
JR said 2011-07-26 10:57 
 
The aftermarket rear turn signals for the DT250, vintage 77-79 have an issue. The mounting stud is 10mm too short. The fix. Remove the stud and tap it to 7mm. Buy a 7mm bolt. Drill it through the center. Changer the hole on both ends. Prevent wire chaffing. Feed the wire through and you are set. A 7mm x 15mm bolt works like a champ. I was working with K&S lights. Bolted up like the originals. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.