RE: 1973 Yamaha DT 125 carb problem

Yamaha DT 125 discussion forum:


RE: 1973 Yamaha DT 125 carb problem

RE: 1973 Yamaha DT 125 carb problem 
Andy H said 2014-11-23 12:55 
 
You are running too lean. Float level may be too low, water in the bottom of the bowl preventing the float falling and releasing the needle valve or most likely is blocked jets. Take them out and blow through with compressed air/lips. You can poke them through with a nylon bristle but not wire or you will scrape away the brass and make the holes bigger. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.