Replacing a footpeg

Suzuki VS 1400 discussion forum:


Replacing a footpeg

Replacing a footpeg 
WNBJ said 2008-08-21 01:41 
 
I purchased a 1990 Intruder 1400 about one month ago. I know, this is a site for a 1995 model, but I think the parts are the same as a 1990. The shifter side footpeg dropped while I was riding it( bolt broke) and I ordered repacement parts from a local Suzuki dealer. To be sure I got at least one set of the correct parts, I went on line and ordered parts also. Parts from both supply sources were identical. The bolt I received that goes through the hole in the cradle and into the threaded back side of the casting after passing through the footpeg frame hole will not fit. the hole in the casting is counter-sunk for a bolt with a head teh same diameter as thed shank of the bolt. The bolt I got from the dealer source has a larger bolt head than the hole in the bottom end casting. Maybe I have an aftermarket set up. If anyone´s had a similar problem and has a solution, e-mail me. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.