SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
Suzuki GSX-R 750 discussion forum:GSX-R Fault Codes (F1 Light) |
| GSX-R Fault Codes (F1 Light) |
| Kev said 2006-01-05 10:47 |
| Im writing this to help others save money and their hair, im also looking for a copy of a 2000gsxr750workshop manual, can you help me? -------When the red light comes on, eg (F1) use these fault codes to find your problem. Im sure they will work ok on all gsxr range after year of 2000. To extract the codes from the computer system, there is a two pinned connector hanging out of the wiring harness, on the left hand rear of the bike, (say above the pillion foot peg under rear trim. Be sure not to confuse the other connector used by the Suzuki Workshop Mechanics, as this has four or five wires to the connector) After locating the one with only two wires at the back, Remove the black rubber cap, use a wire,or split pin or paper clip to bridge the two wires togeather and turn the ignition to the ON position, but do not start it. You should now be able to read the code on the console. The fault codes are as follows,, **** GSXR Fuel Injection (FI) Code List:***** C14 - THROTTLE POSITION SENSOR C15 - ENGINE COOLANT TEMPERATURE SENSOR C21 - INTAKE AIR TEMPERATURE SENSOR C22 - ATMOSPHERIC PRESSURE SENSOR C23 - TIPOVER SENSOR C24 - IGNITION SIGNAL #1 C25 - IGNITION SIGNAL #2 C26 - IGNITION SIGNAL #3 C27 - IGNITION SIGNAL #4 C28 - SECONDARY THROTTLE VALVE ACTUATOR C29 - SECONDARY THROTTLE POSITION SENSOR C30 - SECONDARY THROTTLE CONTROL UNIT C31 - GEAR POSITION SENSOR C32 - INJECTOR SIGNAL #1 C33 - INJECTOR SIGNAL #2 C34 - INJECTOR SIGNAL #3 C35 - INJECTOR SIGNAL #4 C41 - FUEL PUMP CONTROL SYSTEM C42 - IGNITION SWITCH SIGNAL C46 - EXHAUST CONTROL VALVE ACTUATOR (1000 ONLY If anyone can help me with a repair manual for a 2000 gsxr750, please help. Thanks from Kev |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message