RE: 1981 Suzuki GN 400 Shop Manual

Suzuki GN 400 discussion forum:


RE: 1981 Suzuki GN 400 Shop Manual

RE: 1981 Suzuki GN 400 Shop Manual 
That Graham Guy said 2006-08-24 20:02 
 
The GN 400 did not have an after market manual, but If you look, you may find one for the 400cc dirt bike (it was the same engine, charging, etc).

As for starting the bike, here is the ritual:
1) Key on
2) Set kill switch to RUN
3) Set choke
4) pull decompression lever (it should stick in)
5) slowly press kick-starter only until level pops back out
6) return kick start lever to the top
7) smoothly kick the bike and it should start right up
8) then re-adjust choke 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.