scarred up slider on variable venturi cause leanout?

Kawasaki KZ 750 discussion forum:


scarred up slider on variable venturi cause leanout?

scarred up slider on variable venturi cause leanout? 
Dan said 2009-06-28 01:07 
 
Soaked carburetors and all internal parts in ultra-sonic sound cleaner, hot soapy solution. spots of teflon coating came off floating variable venturi pistons. Can this cause a lean out condition at lower to mid speed ranges? Only way bike will run is with enrichener on full choke. I have been completely through these carbs twice, with air and carb cleaner in a spray can. Near as I can tell, all passages and jets are clear. Sliders seem to float freely with finger. Any suggestions? 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.