SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
Kawasaki KLR 250 discussion forum:wont start |
| wont start |
| marc aucoin said 2006-05-07 15:34 |
| I just purchased this bike about three weeks ago and it was running ok, had some stuff in the float valve and cleaned it and it ran good agian. It was reading high on the temp gauge, however I could still hold my hand breifly on the top of the heads so I suspected a faulty sending unit and continued to ride another ten miles home. The next morning it started hard and was having a hard time idling, the next time it started even harder and would not idle at all, warm or cold. Then it would not start at all. I have checked spark, compresion is about 50psi cold with a rubber compression adapter. I even tried spraying either into the system and got no response, not even a burp. I have cleaned the carb thuroughly and carefully, but the either thing is seeming to point me to a different problem. If in fact I did run the engine too hot for too long what could happen, and wouldnt the compression show up less than 50psi or is 50psi bad for a cold engine? Help,,,, I am about to pack it up and send it into a shop!!! marc |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message