Awtistiaeth

Kawasaki ER-5 discussion forum:


Awtistiaeth

Awtistiaeth 
cadno coch said 2024-02-04 00:28 
 
Hi folks. I have a 1998 er5 that I need to fit a 2nd-hand electronic rev-counter to and that needs fitting into a new clock case as all the cases have been bodged on. Unfortunately, I could only find a 2nd-hand GPZ 500 rev-counter (same part number for an er5) in a complete set of GPZ clocks. I´m happy to strip and swap over, but am concerned I will lose the setting/pre-load for zero once I remove the needle. Am I correct? If so, how do I get around this issue? Maybe ´have the dash powered up and place the needle at zero-revs´ is one thought I had. Grateful for any knowledge on this, as electronics and don´t get on! 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.