mr

Honda XL 600 discussion forum:


mr

mr 
scott said 2011-03-23 12:31 
 
looking for some advise on my xl600lmf its a very clean bike and hasnt been messed about with at all, the bike starts and runs fine every time, but when im going over a certain rev, there is a massive flat spot. i originally thought this was a carb isssue, but i took them apart cleaned them and raised the needle one notch (onto the very bottom notch) to see if more fuel to the high rev carb would make a difference but it didnt, well it might have pulled a little better but problem still there so i put it back, am i looking at a electrical thing here? any advise would be appreciated. i dont see how giving it more fuel would fix it when it must of been running as it is fine at some point. so it pulls fine up to a point then just flat, if i open it right up it dies, if i accelerate very slowly it pulls, and if you make it through tthe flat spot it starts pulling again just in time for the red line ha ha. cheers, scott 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.