Daniel

10 Honda CBR1000RR discussion forum:


Daniel

Daniel 
2010 cbr1000RR said 2010-07-27 13:48 
 
I recently purchased a 2010 Cbr 1000RR and after putting 636 miles I changed the oil to synthetic and went to get a baseline dyno run. I live in Florida and when I did a 4th gear roll-on the bike produced 141.89 whp but after a couple of runs I measured the exhaust gases using the ega on the dyno. When I did 3 more runs I noticed that it was running super rich from right around 9000 rpm to redline, the air/fuel ratio dropped to almost 12.0 to 1 a/f ratio. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title
 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 2010 Honda CBR1000RR information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 10 Honda CBR1000RR. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.