Need to pull motor, sorry. Clymer manual #M335, may be available at your local Honda dealer or motorcycle repair shop. Check out gaskets needed and be sure to replace shift shaft seal. o-ring on timing chain adjuster bolt and I would really recommend replacing the water pump mechanical seal and the camshaft oil seal while you have the rear cover off. Pay close attention to the rear cover removal and installation procedures, it´s easy to have the shift selector teeth to become mis-aligned. Make sure that you mark the ignition pick up plate before removal that way, you won´t have to worry about tearing the whole rear suspension out to set the timing. Not really a hard job, just labor intensive. Good luck and e-mail me if there is anything else I can do.