RE: 1984 CM250 Custom stalling out

Honda CM 250 discussion forum:


RE: 1984 CM250 Custom stalling out

RE: 1984 CM250 Custom stalling out 
ChrisW said 2016-02-19 22:40 
 
I had the same problem and the shop was unable to fix it. I eventually found the problem myself, it turned out that the carburettor was not fixed with an air-tight seal onto the cylinder. It was sucking air from outside rather than through the carburettor. I simply tightened the jubilee clip and it runs perfectly.
I also think that in running so lean it had damaged the spark plugs which I later replaced.
 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title
 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.