RE: few prob

Honda CB 750 discussion forum:


RE: few prob

RE: few prob 
arbuckle said 2009-03-05 00:38 
 
Replace the choke cable and that will likely fix that problem.

As far as the front break goes that gets a bit more complicated. My bike had an issue where the pressure in the lines wasn´t getting releaved as heat increased and the break would slowly close.

The fix to that was to pull off the master cyl reservour (the plastic thing on top of the break handle). When you pump the break fluid should spray up out of a small hole, if it doesn´t there is a clog in that little lazered hole. You will see one big hole when you will see the pump move, and then what looks like a very small indent. Take a needle and push into the middle of that indent. As soon as you can pump the break and fluid sprays out you know you have it cleared. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.