Nozzle dimensions in the carburators

Honda CB 750 discussion forum:


Nozzle dimensions in the carburators

Nozzle dimensions in the carburators 
kees maas said 2007-10-15 12:03 
 
I purchased here in the Netherlands a 1981 CB750C with only 25000km on the tacho.. which was stored for 5 years..

When testing i found that both cylinder 2 and 3 were not running along with the other cylinders...

now i decided to open the carbs.. and found that 7 of the 8 nozzles had the same size and found one with a bigger size.. now the question is is this normal and if so where should the bigger one be fitted..

Any suggestions on what could cause the 2 cylinders not working are welcome..

Or a scanned picture on the internals of the carbs. would also be welcome..

kees Maas 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.