SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
Honda CB 500 discussion forum:1975 Honda CB500T Cafe Racer Project |
| 1975 Honda CB500T Cafe Racer Project |
| Kiyoshi-Yamada said 2015-05-04 13:53 |
| Hello everyone, this is my first post on this forum. I just acquired a 1975 Honda CB500T from my soon to be father in-law. The engine, gas tank, and other various parts were kept in out of the weather, but the frame and rest of the parts were outside. He was using it as a bike to commute to and from work, until he started having issues with it. From what I understand the cylinder wall ended up being scored, so he fixed it all, but never completed the reassembly. The main reason I´m posting is for guidance in this project. Due to the frame being outside, it needs cleaned up and re- powdercoated. The chrome on the bike is pitted all over the place, especially the forks. But I´m not too terribly worried about wiring, brake lines, fuel lines, etc. because I´m planning on replacing all of that. I found a few different sites that have OEM wiring harnesses and such. The main thing I´m having issues with at this point is finding new forks for it. I´m not sure if I need to get forks that are specifically for this bike or if there are other forks that will fit it. I was thinking about getting the current ones re-chromed, but wasn´t sure what the cost comparison of getting a whole new front end assembly would be compared to the cost of new chrome. Any comments or suggestions are welcome and appreciated. Thank you, Tim |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message