RE: Russell

Honda CB 360 discussion forum:


RE: Russell

RE: Russell 
Mike said 2008-07-21 20:42 
 
If I were you I would replace it. Pulling the carbs off isn´t that tough. Disconnect the fuel lines (make sure the gas is off). You´ll probably want to take the tank off because the petcock will get in your way. Take off the air filters. Loosen the clamps holding the carbs on the cylinder intake boots. Then you should be able to wiggle it off. You shouldn´t have to take the throttle cables off although it´ll be easier to work with that way. The idle screw pushes on the pulley that the throttle cables attach to.
While trouble shooting my carbs this morning, I backed my idle screw out too far. I had to take the carbs out to thread the screw back into the guide that directs it at the throttle pulley. It only took about half an hour. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.