RE: epcarol

Honda CB 360 discussion forum:


RE: epcarol

RE: epcarol 
JeremiG said 2006-03-24 04:31 
 
My CL360 has and endless cam chain as do all of the 360´s I believe (someone correct me if I´m wrong) on the front of the motor near the bottom you will find a bold and locknut, with the Number 1 Cylinder at top dead loosen the locknut and loosen the bolt... this will allow the auto adjuster to take up the slack in the chain, then tighten the bold and locknut, done.. to replace you will have to pull the top end apart, break your old chain, the new chain you get should be open then you can link them together and fish the new chain through your crank case, then remove old chain and rivet your new chain together, of course you will need a chain breaker/riveter and pin set, gaskets etc. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.