Daniel

Honda CB 1000 discussion forum:


Daniel

Daniel 
2010 cbr1000RR said 2010-07-27 13:48 
 
I recently purchased a 2010 Cbr 1000RR and after putting 636 miles I changed the oil to synthetic and went to get a baseline dyno run. I live in Florida and when I did a 4th gear roll-on the bike produced 141.89 whp but after a couple of runs I measured the exhaust gases using the ega on the dyno. When I did 3 more runs I noticed that it was running super rich from right around 9000 rpm to redline, the air/fuel ratio dropped to almost 12.0 to 1 a/f ratio. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.